Pipe designers and drafters provide thousands of piping drawings used in the layout of industrial, Oil and Gas, marine vessels, and other facilities. The layouts must comply with safety codes, government standards, client specifications and budget. TRIPLE D Engineering, offer Piping Drafting and Design, through the creation of piping arrangement and isometric drawings using symbols for fittings, flanges, valves, and mechanical equipment. We use latest software technology for design of complex piping system.
Our systematic arrangement of drawings that begins with the layout of the structural foundations of a facility and continues through to the development of a 3-D model. Which include elevation, section and isometric drawings are extracted including bills of material.
Piping Stress Analysis and Design
Pipes are the most delicate components in any Construction. They are also the busiest entities. They are intentionally or unintentionally subjected to almost all kinds of loads. It is very important to take note of all potential loads that a piping system would encounter during operation as well as during other stages in the construction life cycle. Ignoring any such load while designing, erecting, start-up shut-down, normal operation, maintenance etc. can lead to inadequate design and engineering of a piping system. The system may fail on the first occurrence of this overlooked load. Failure of a piping system may trigger a Domino effect and cause a major disaster. Stress analysis and safe design normally require appreciation of several related concepts. TRIPLE D Engineering follows an approximate list of the steps that would be involved
- Identify potential loads on to the pipe or piping system during its entire life.
- Relate each one of these loads to the stresses and strains that would be developed in the Material of Construction of the piping system.
- Decide the worst three-dimensional stress state that the Material of Construction can withstand without failure
- Get the cumulative effect of all the potential, loads on the 3-D stress scenario in the piping system under consideration.
- Alter piping system design to ensure that the stress pattern is within failure limits.
We maintain goal of quantification and analysis of pipe stresses is to provide safe design through the above steps.
Piping Drafting & Detailing
- Piping Isometrics and fabrication drawings
- Pipe support arrangements drawings
- Preparation of requisition for quotations as per P&ID
- Generation of Bill of Material (BOM), Bill of Quantity (BOQ) & Material Take Off (MTO)
